Be sure the console does not instantly boot into the dashboard. You should see the console logo and some sound effects indicating that the unit is on. Once you confirm that the unit has shut down completely, press the Power button once again to power it back up. You want to be sure that the console is completely powered down in order for the process to be performed properly. If you only press it down and release it quickly, you are only going to put the device in Sleep mode. However, it is critical that you also perform a hard reset of your game console, as well.įirst, hold down the console’s Power button for up to 10 seconds, allowing the console to fully shut off. By installing these firmware updates, you should be guaranteed that the solid red light issue will not happen again. The Audio Hub will detect your headset, then search for all available and appropriate firmware updates, and then ask you to install each of them that is applicable. Then, you power your headset on, and using the USB cable that was included with the unit, plug the headset into any free USB port on your PC. This is actually pretty easy, and it applies to both the Turtle Beach Stealth 600 and Stealth 700.įirst, be sure that the Turtle Beach Audio Hub is running on your computer. The easiest way to prevent that irritating unresponsive state, where the LED light stays a solid red color, is to apply the firmware update. Is There Any Way to Prevent the LED Light from Becoming Stuck on Solid Red Again? Lastly, you could just wait until the battery dies on either model headset and just recharge each one as usual. Users have said they have seen better results doing this.Īnother way to reboot the Turtle Beach Stealth 700 model is to press and hold down the Bluetooth, Power, and Mode buttons at the same time for at least 10 seconds. It is always best to do this when the unit is already connected to a power source. On the Stealth 700, press and hold down the Mode and Bluetooth buttons at the same time for 20 seconds or longer. Holding them down longer is better than doing so for a shorter period of time. You will need to follow different instructions depending on which model you have chosen.įor the Stealth 600 headset, press and hold down the Mode and Connect buttons together for at least 20 seconds. If this is the case, you will have to conduct a hard reset of your Turtle Beach Stealth 600 or Stealth 700 headset. What if my Headset is Displaying the Solid Red Light for no Apparent Reason? However, if the headset is powered off as it is charging, the solid red LED light will simply turn off completely after the device is done charging. If the device is powered on while it is charging, the LED light will change to a blinking blue tone when it is completely charged. The LED light will display differently, however, depending on whether the headset is powered off or powered on while it is still charging. The only way to fix this, if it is indicative of a low battery, is to fully charge the unit. At that point, whether you own the Turtle Beach Stealth 600 or Stealth 700, the LED light should change to solid red by default. You will need to plug the unit in to charge. When your headset’s battery is beginning to get low, you will notice that LED light will blink red. Will Charging my Headset Always Eliminate the Solid Red Light? Is There Any Way to Prevent the LED Light from Becoming Stuck on Solid Red Again? 1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |